Description
Hydraulic Geroler Disc Valve Motor – 6000 – Standard, 312 cm³/r Max Geometric Displacement
Actual Mounting Flange: Standard; (SAE CC); 4 Bolt; 127.0 [5.00] Pilot Dia. 14.35 [.565] Dia. Holes On 162.0 [6.38] Dia. Bolt Circle
Series: 6000 – Standard
Actual Output Shaft: Straight
Actual Port Type: 1.3125-12 UN-2B SAE O-Ring Ports – Staggered Ports
Continuous Flow Rate: 150 L/min
Displacement: 19.04 in³/r
Drain Connection Size: .4375-20 Unf-2b O-ring Port Size -4
Maximum Operating Temperature: 180 °F
Intermittent Pressure: 310 bar
Maximum RPM-Continuous: 387 rpm
Mounting Type: 4-Bolt
Replacement Balance Ring – Sold Separately: 006 & 005 Design – 21317-000 – 1 Required
Replacement Buna Seal Kit – Sold Separately: 006 & 005 Design – Rear Seal Kit 61238-000, 006 & 005 Design Shaft Seal Kit – 61237-000 – 1 Required
Operation Mode: Continuous Rating – Motor May Be Run Continuously At These Ratings. / Intermittent Operation – 10 Percent Of Every Minute / Peak Operation – 1 Percent Of Every Minute
Operation Rating Description: Continuous Rating – Motor May Be Run Continuously At These Ratings. / Intermittent Operation – 10 Percent Of Every Minute / Peak Operation – 1 Percent Of Every Minute: Output Shaft Size
1-1/2 in Straight – Straight Key: Replacement Drive Valve – Sold Separately 006 & 005 Design – 8508-000 – 1 Required:
Overall Height: 5.78 in:
Overall Length: 11.68 in
Replacement Housing, Bearing Side (Front) – Sold Separately: 006 Design – 201839-001, 005 Design – 8490-000 – 1 Required
Overall Width: 5.78 in
Replacement Long Cap Screw (Cap End) – Sold Seprately: 006 & 005 Design – 14409-003 & 14409-007 – 2 Required Of Each Bolt
Port Configuration: 1.3125-12 UN-2B SAE O-Ring Ports – Staggered Ports
Port Orientation: Staggered Ports
Replacement Output Shaft and Bearing Kit – Sold Separately: 006 Design – 201837-001, 005 Design – 8711-001 – 1 Required
Replacement Plate Valve – Sold Separately: 006 & 005 Design – 21666-000 – 1 Required
Replacement Rear Housing – Sold Separately: 006 & 005 Design – 8502-004 – 1 Required
Replacement Drive – Sold Separately: 006 & 005 Design – 21373-003 – 1 Required
Replacement Valve-Sold Separately: 006 & 005 Design – 8497-000 – 1 Required
Replacement Viton Seal Kit – Sold Separately: 006 & 005 Design – 61246-000 – 1 Required
Replacement Geroler – Sold Separately: 006 & 005 Design – 8507-003 – 1 Required
Maximum Continuous Oil Viscosity: 70 Saybold universal second
Seal Type: Standard
Shaft Type: Straight
Reviews
There are no reviews yet.